| Join the Coe Press Equipment Mailing List |
|
|
|
|
Complete space saving coil fed line installed by Coe Press Equipment
Installed
at: Toledo Tool and Die, Toledo, Ohio. Installed on AIDA
600 ton PMX press. Automotive stamping production.
7
Roll Pull-Thru Straightener
Model No. CPRF-742
AC Servo Drive Digital Roll Feed
| Maximum
Material Thickness: |
.100”
x 40” Wide MCRS
.312”
x 12” Wide MCRS
.250”
x 9” Wide, 80,000 Yield |
Close
tolerance clusters – geared upper & lower feed rolls.
Air operated pilot re-release mechanism. Master control station
in common press/feed console. Remote jog with coil cord. Heavy-duty
cabinet base with passline adjustable +/- 5” by means
of 10,000 lb. leg jacks. Entrance edge guide w/self centering
& independent handcrank adjustment with 3” diameter
edge guide rolls.
|
| Standard
Features: |
- 7
roll pull thru straighter (Model No. JXPHS-42)
-
5” diameter straightening rolls, hardened and ground
-
Upper backup rolls to prevent straightener roll deflection
-
Power threading rolls with #3 matte chrome coating
-
Air raise and lower of powered pinch rolls
-
Pinch roll jog forward and reverse
-
Material support table between press columns
-
Motorized passline height adjustment with “tools free”
press mounts
-
Overhead cable set to support feed cables
|
Free
Standing Peeler/Threader/Hold Down Station
Facilitates hands free coil threading. Hold down arm, peeler table,
and adjustable breaker bar with 16” motorized endwheel. Heavy-duty,
self-centering edge guide, hand crank operated on operators side to
center and contain coil. Material support table to facilitate coil threading.
Traveling
Coil Reel
Model No. CPTR-30042
| Maximum
Coil Weight: |
30,000 lbs. |
| Maximum
Coil Width: |
42
Inches |
Traveling
reel with scales on track to center coil. 3 pad mandrel design.
Hydraulic mandrel expansion. Pneumatic and hydraulic controls
are solenoid operated.
|
| Standard
Features: |
- Full
OD backplate set up for 72” OD coil
-
Three pod eyes mounted on backside of clock spring guard
-
Selector switch to change loop area based on material
-
Speed potentiometers to control maximum mandrel speed
-
Accel and decel programmable through ABB drive in reel
-
7.5 HP variable speed drive
-
Stationary hydraulically operated coil lift
-
18” of lift on stationary coil lift
- Adjustable
anti-tip arms
|
| Special
Options: |
Powered outside coil guide assembly. Powered up/down and in/out.
Mounted outside range of three pod eyes. One set of three (3)
short coil keepers to prevent material from slipping under powered
coil guides.
|
Top
of Page
|
|
|
